从废水到新能源:光催化燃料电池的优化与应用

随着经济的飞速发展,社会对能源的需求日益扩大,对工业废水的无害化处理也提出了更高的要求。光催化燃料电池 (photocatalytic fuel cell, PFC) 在燃料电池中引入半导体光催化材料作为电极,实现了有机污染物高效降解和同步对外产电的双重功能,在废水无害化与资源化利用方面具有潜在的应用价值。半导体光催化电极是PFC系统高效运行的核心组件,增强其可见光响应和光生载流子分离是提高PFC性能的关键策略。反应器结构设计和运行参数优化也有利于改善PFC性能。本文从PFC基本原理和应用入手,综述了PFC在环境污染物资源化处理中的研究进展,并详细阐述了提高PFC的污染控制性能和产电效率的优化手段,为进一步设计高效稳定的PFC系统并实现其在水污染控制和清洁能源生产中的应用提供理论指导。     

外腔反馈对半导体激光器振荡特性的影响

通过有效反射系数的引入，根据激光谐振腔的自再现条件和对腔内光子密度、载流子密度方程的求解，分析了外腔反馈对半导体激光器的阈值增益、振荡频率和输出功率等振荡特性的影响，并通过实验进行了验证.外腔反馈后，半导体激光器的阈值电流从420mA降为370mA，输出功率的斜率效率获得了提高，理论计算的输出功率曲线与实验结果符合的很好. 关键词： 半导体激光器 外腔反馈 振荡特性     

半导体激光器光束准直系统的功率耦合效率

在长距离无线光通信中，接收点光功率密度与光束发散角平方呈反比关系，为了获得小的发散角和大的功率耦合效率，要求准直系统有较大的数值孔径(NA)，但数值孔径过大会增加像差，因此合理设计功率耦合效率与准直系统的数值孔径就非常重要。该文对半导体激光器光束准直系统中功率耦合效率进行了研究，给出了半导体激光器光束功率耦合效率与k(孔径半径与孔径处等效光束半径之比)的关系表达式，并结合激光器光束准直系统，给出了半导体激光器光束功率耦合效率与准直系统数值孔径的关系表达式。该研究结论对于半导体激光器光束准直系统设计具有参考作用。     

SiOx纳米管的制备及其发光特性

以液态金属镓为媒介,利用热蒸发法合成大量非晶SiOx纳米管,这些纳米管管径均匀分布,平均约80 nm,长度大于10μm,且管内外径比例较小．分析发现,在实验过程中,熔入金属镓液滴中的硅元素和氧元素结合并从液滴的表面饱和析出,形成以镓为中心的非晶SiOx纳米管状结构．在室温中,利用260 nm的激发光源激发SiOx纳米管,发现在蓝光波段附近发出强而稳定的PL谱线,这可能与样品中的氧缺陷和空位有关．     

Fiber-Optic Chemical Sensor for Detection of NO2 Using Poly (3-Octylthiophene)

A fiber-optic chemical sensor (FOCS) for detection of nitrogen dioxide (NO₂) molecules is reported. The FOCS presents an optropode structure because of the transmission properties of the sensitive material. The NO₂ FOCS is activated by using the semiconductor polymer: regioregular head-to-tail poly(3-octylthiophene-2,5-diyl). The operation wavelength of the sensor is 543.5 nm such that a simple LED and detector can be used for the design of this device. The sensor response decreases after each exposure, demonstrating the reduction in sensitivity as well as irreversibility lower than 5%. However, its properties such as rapid response, high selectivity, high sensitivity (0.43 ± 0.01 muW/ppm), hygroscopic properties, and its operation at room temperature make this kind of FOCS a good alternative for NO₂ toxic gas detection.     

Single to 16-Channel Wavelength Conversion at 10 Gb/s Based on Cross-Gain Modulation of ASE Spectrum in SOA

A simple scheme for single to multi-channel wavelength conversion based on cross-gain modulation of amplified spontaneous emission (ASE) spectrum in semiconductor optical amplifier (SOA) is described. Single to 16-channel wavelength conversion at 10 Gb/s is first demonstrated without any additional probe lights, the modulation information carried by input signal could be converted into arbitrary many channels if only the demultiplexer with enough channels is exploited. Output performance and pattern effects are investigated experimentally.     

Volumetric and infrared measurements on amorphous ice structure

We have simultaneously used adsorption isotherm volumetry and Fourier transform infrared spectroscopy in order to take the investigations on amorphous ice structure a step further, especially concerning porosity and annealing-induced modifications. We have studied surface reorganization during annealing and found that the number of surface sites decreases before crystallization, their relative ratios being different for amorphous and crystalline ice. We also present results confirming that ice can have a large specific surface area and nevertheless be non-microporous.     

New insights on amorphous silicon-nitride microcavities

All amorphous silicon-nitride planar optical microcavities operating in the visible range have been grown by plasma enhanced chemical vapor deposition. The luminescence intensity of the N-rich silicon-nitride layer from a microcavity with 6 period distributed Bragg reflectors (DBRs) is two order of magnitude higher than that of the luminescent layer without the cavity. Moreover, a strong directionality of the microcavities emission can be observed. Such results can be ascribed to the anisotropic optical density of states induced in the Fabry–Perot structure. The quality factors of the resonators are strictly correlated to the number of periods of the DBRs.     

A Semiconductor Laser of the Visible Range as an Exciting Source of Raman Scattering

A possibility of application of semiconductor lasers of the visible range as exciting sources for Raman spectroscopy is studied. An experimental set-up for measuring Raman spectra of polycrystalline dielectrics and broad-gap semiconductors excited by a semiconductor laser with a wavelength of 640 nm was created. The conditions under which the spectral width of the lasing line of a semiconductor laser was within 10^-3 cm^-1 in the continuous mode with a power of 10 mW are realized. The characteristics of various types of exciting sources used in Raman spectroscopy are compared. The results of studies of the characteristic Raman spectra excited with a semiconductor laser in polycrystalline sulfur are presented.